Burnham SCG 1100-H4 Spécifications télécharger pdf

83 Water Street • New Haven, CT 06511 • Phone (203) 776-0473 • FAX (203) 773-1019 • www.hydrolevel.com

•

ADVANCED SOLID STATE DESIGN

• TEST BUTTON FOR EASY DIAGNOSTICS

• POWER AND LOW WATER LED INDICATORS

• MOLEX CONNECTOR FOR EASY WIRING

• COMPACT SIZE ALLOWS FOR MOUNTING IN TIGHT SPACES

Step



Step



Step



Step



Low Water Cut-Off

For Residential

Hot Water Boilers

24 VAC Operating Voltage

Model 1100

Determine Mounting Location

The Safgard 1100 must be installed at or above the

minimum safe water level established by the boiler

manufacturer. The 1100 can be installed directly into

the boiler if a suitable tapping is available

훽

. The

1100 can also be installed in the boiler piping using a

standard 3/4" tee

훾

Note: When installing in piping, select a location

close to the boiler to ensure the 4' wiring harness will

reach the 24-Volt transformer. The cut-off should be

installed on the boiler side of the circulator or shut-off

valves.

IMPORTANT: Check for adequate clearance

(minimum 1/4") from metal probe sensor to any

surface inside the boiler or pipe.

Do not install in a location that could hold or trap

water in the event of a low water condition.

Apply Teflon

tape to

the threads of the

Model 1100. Do not

use pipe dope or

other pipe sealants.

Hand tighten the

control into boiler

tapping or pipe tee.

Be careful not to

cross thread.

Note: Do not use a

wrench. Hand tight-

en only.

Plug wire harness

into connector on

face of control.

WARNING

Electrical shock hazard. To prevent electrical shock, death or

equipment damage, disconnect power supply before

installing or servicing control. Only qualified personnel may install or service this control in

accordance with local codes and ordinances. Read instructions completely before proceeding.

CAUTION

To prevent serious

burns, boiler

should be thoroughly cooled before installing or

servicing control.

WARNING

Frozen pipes/water damage. Central heating systems are prone to shut down as a result of power or fuel outages,

safety related fault conditions or equipment failure. Installation of freeze protection monitoring or other precautions

is recommended for unattended dwellings in climates subject to sustain below-freezing temperatures.

Model 1100 Instructions: Model 1100 Instructions 4/30/12 10:24 AM Page 1

1 2 3 4

Résumé du contenu

Page 1 - 24 VAC Operating Voltage

83 Water Street • New Haven, CT 06511 • Phone (203) 776-0473 • FAX (203) 773-1019 • www.hydrolevel.com•ADVANCED SOLID STATE DESIGN• TEST BUTTON FOR EA

Page 2

WIRING TO CONTROL CENTERFor boilers equipped with a Honeywell R8285 Control Center or equivalentWIRING TO AN AQUASTATFor boilers equipped with a Honey

Page 3 - WIRING TO 24 VAC TRANSFORMER

WIRING TO 24 VAC TRANSFORMERFor boilers using a standard 24 VAC transformerBOILER SPECIFIC MODELS AND WIRE HARNESSESConnect RED wire tohotside of 24 V

Page 4 - SPECIFICATIONS

LIMITED MANUFACTURERʼS WARRANTYWe warrant products manufactured by Hydrolevel Company tobe free from defects in material and workmanship for a periodo

Commentaires sur ces manuels

Pas de commentaire

Burnham SCG 1100-H4 Spécifications

Naviguer en ligne ou télécharger Spécifications pour Chauffe-eau et chaudières Burnham SCG 1100-H4. Burnham SCG 1100-H4 Specifications Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffe-eau et chaudières Burnham SCG 1100-H4